Join Date: Nov 2009
Location: St. Louis Missouri
Re: Indestructable (?) Skid Plate
I guess I should have mentioned that I made this with the use of a cutoff wheel on a grinder, a hand drill, and about an hour of time! Total cost = $2.75!!! Steel was a piece I had laying around. Went through one cutoff wheel triming it all down.
A concern I had with the plastic (stock or otherwise) is that it was allowed to deflect up and contact the bottom of the transmission. And based on the cost required to replace a transmission..........I look at that as if I have a brick of gold in the back of my rig! So I'm all about protecting that sucker!
I have a piece of 4130 plate. Think I might have found a good use for it. Broken trans
Never pay again for live sex! | Hot girls doing naughty stuff for free! | Chat for free!